Calcure C30 - Wax Based Curing Membrane

  • Calcure C30 - Wax Based Curing Membrane

Calcure C30 is an economical, sprayable, wax based curing compound, which seals the surface of fresh concrete, reducing moisture loss and providing high-efficiency curing. Calcure C30 Complies with AS 3799 and RTA 3202.

Premium Quality
Economic Solution
Complies to Australian Standards
Wax Based
Item Code
See Availability Tab
Pack
20L, 205L, 1000L

Available Options

Where recommended

All concrete surfaces which require high efficiency curing and areas to which standard curing methods would be difficult or uneconomical.

High efficiency concrete curing by a single spray application, without covering or continuous water spray/ponding. Calcure C30 Complies with AS 3799 and RTA 3202.

Calcure C30 may also be used as a de-bonding agent. When used for this purpose, a minimum of two coats should be used, applied at right-angles to each other to avoid any pinholes. A trial area is always recommended to be done to confirm satisfactory performance.

Note

If cementitious or other materials are to be bonded to surfaces to which Calcure C30 has been applied, prior removal of the Calcure C30 by sandblasting or solvent treatment is recommended before bonding is attempted.

Code Item Pack
7520 Calcure C30 - Wax Based Curing Membrane 20L 20L
10661 Calcure C30 - Wax Based Curing Membrane 205L 205L
17879 Calcure C30 - Wax Based Curing Membrane 1000L 1000L

How to specify:

All concrete shall be cured by a liberal application of  Calcure C30 sprayed onto the surface as soon as possible after finishing or removal of forms, at a rate of 5 square metres per litre

Caution:

CALCURE C30 is best stored out of direct sunlight, and has a shelf life of 3 months maximum.

Do not specify Calcure C30 or any other curing compounds where liquid surface hardeners such as Cementaid Diamite are specified to be used, as penetration of these treatments would be impaired. In such cases, specify water-curing, damp sand or building plastic.

For application service:

For application, “Rega” or equivalent pneumatic knapsack spray is recommended, with a No. 9, 10 or 11 fantail nozzle. Equipment should be cleaned by flushing thoroughly with water.

Tech Data Sheet
Tech Data Sheet
Safety Data Sheet
Safety Data Sheet


If you have any questions please ask us
Subscribe to our newsletter