NuTech PaveCoat AntiSlip Mix In

Improves slip resistance on sealed concrete surfaces using NuTech single-pack sealers.

Pack

400gm Jar

Available Options

Qty

PaveCoat AntiSlip Mix In improves slip resistance on sealed concrete surfaces using NuTech single-pack sealers. Ideal for safer walkways under wet or dry conditions.

Durable
Green Concrete
Low Odour
Waterproof

Description:

PaveCoat AntiSlip Mix In – Enhance Surface Safety for Concrete Sealers

PaveCoat AntiSlip Mix In is a purpose-built friction enhancer designed to reduce slip hazards on freshly sealed concrete surfaces significantly. Developed by NuTech Paint, this additive boosts the slip resistance of NuTech single-pack concrete sealer systems, including PaveCoat, PaveCoat Petrol Resistant, PaveCoat H2O, and EPiC Industrial Enamel.

When used correctly, AntiSlip Mix In creates a more secure walking surface under both wet and dry conditions. It helps achieve a Pendulum Slip Rating of P2 or P3, complying with AS4586 and AS4663 standards, making it ideal for environments where pedestrian safety is a priority.

Key Features:

Improves surface grip in wet and dry conditions
Easy to mix into NuTech single-pack sealer systems
Flexible and scuff-resistant finish
Reduces personal injury risk without an overly abrasive texture
Complies with Australian slip resistance standards

Benefits:

Substantially improves safety of sealed surfaces in wet and dry conditions
Simple mixing to achieve a uniform distribution
Flexible and scuff resistant
Less abrasive surface to reduce personal injury due to falls

Application:

For detailed substrate preparation and application steps, please download the full application guide.

Test Patch: NuTech Paint recommends that applicators test any AntiSlip system first as varying surface profiles, slopes and access conditions vary significantly with individual conditions. These variants impact heavily on pedestrian and vehicle safety.

Application Procedure:

Mix and apply first coat of the selected NuTech sealer in accordance with the relevant TDS and application method, allow to dry.
AntiSlip Mix In is only required in the final topcoat of the NuTech Paint system.
Mix the selected NuTech Paint system in accordance with the relevant TDS.
Add AntiSlip Mix In in the following ratio; Mix ratio: (optimum performance) P2 Rating – Min. 400 grams (1 tub) per 20L of Paint product, P3 Rating – Max. 800 grams (2 tubs) per 20L of Paint product.
Stir into the NuTech Paint system product to be used for top coat. Stir well until no visible lumps. Allow to stand for 10 minutes, re-stir prior to use. Keep blended product agitated.
Apply mixed NuTech Paint system in accordance with the relevant TDS and application method. A small amount of dry AntiSlip Mix In can also be broadcast onto the surface and then painted over for extra non-slip properties.
Refer to the table regarding AS4586 & AS4663 mix ratio requirements. Increasing the quantity of AntiSlip in the topcoat will increase the surface friction however, AntiSlip Mix In may become visible or leave a patchy appearance if over added.

ReCoat: AntiSlip Mix In is to be added and applied in the final coat only. Refer to specific NuTech system TDS for specific re-coat times.

Typical Applications:

Ideal around wet areas, pools, factory loading docks, access ramps (with less than 15 degrees incline), stairs, entrance foyers, public pedestrian and vehicle areas.

Suitable Surfaces:

Concrete Pools
Concrete Slabs

Warnings:

AntiSlip Mix In IS NOT suitable for inclined or steep surfaces.
NOT RECOMMENDED for use in 2 pack concrete finishing systems OR in AquaStop or Silicon Sealer.
Nutech recommends the use of PolyCryl and the addition of AntiSlip Cast On to achieve up to an R12 or P5 slip rating. Refer to the relevant TDS for further information.