Vulk - Finseal Glow One Coat
Solvent based high-gloss protective coating for decorative concrete paving and masonry surfaces
Solvent based high-gloss protective coating for decorative concrete paving and masonry surfaces
Finseal Glow ONE COAT is a very high solids solvent based highgloss protective coating formulated for one coat application to a wide range of decorative concrete paving and masonry surfaces requiring heavy duty protection.
Finseal Glow ONE COAT is recommended for application to stencil, coloured, stamped concrete, exposed aggregate and is suitable for pedestrian and vehicle traffic such as driveways.
This very hard-wearing product has a good resistance to petrol, oil, hydraulic fluids, mould, algae and protects substrates from the ingress of dirt, grime and organic matter.
Due to the high solids formulation Finseal Glow One Coat is able tobe applied in one coat, saving time and money, while enhancing theappearance and resisting deterioration of the treated surface.
| Resin Type | Acrylic 32% NVM |
| Specific Gravity | 0.92 |
| Viscosity | 50-100cps |
| Film build (recommended) | 100um @ 3-3.5m2/L |
| Thinning | Xylene |
| Recoat window | 24 hours |
Curing is dependent on the temperature. The sealer is usually touchdry in approximately 30 minutes at 25˚C.
Protect the sealed surface from rain, water and sprinkler systems for a minimum of 6 hours. Accessible to foot traffic after 24 hours and vehicle traffic after a minimum of 5 days.
Coverage is approximately 3–4m2 per litre per coat. Theoretical coverage for a 1 coats application is approx. 30–40m² per 20 litre drum.
The properties of the substrate such as porosity and profile will influence the coverage rate and number of coats required.
Areas to be treated must be clean, dry, free from oil, grease and surface curing compounds.
Freshly laid concrete should be left to cure for a minimum of 7 days prior to application, unless treated with Finseal Glow PS, a same day sealer after finishing.
Remove all dirt, grease, oil, paint or curing compounds with Finseal Paveclean / TyreClean or suitable general-purpose cleaner or stripper. Thoroughly wash and pressure clean surface.
A light acid etch prior to application is recommended to ensure unreacted laitance is removed prior to applying to new stamped or exposed aggregate concrete.
Pressure clean surface at minimum 2000psi to prepare for sealing. Allow surface to dry prior to application of the sealer.
Ensure surface is thoroughly prepared and dirt, grease, staining, oils and contaminants are removed with Fincare Paveclean / TyreClean followed by thorough scrubbing or pressure washing at minimum of 2000psi.
A light acid etch prior to application is recommended to ensure unreacted laitance and loose cementitious material is removed prior to sealing and increase penetration of the prime coat.
Pressure clean surface with a minimum 2000psi to prepare for sealing. Allow surface to dry prior to application of the sealer.
Ensure surface is thoroughly prepared and dirt, grease, staining, oils and contaminants are removed with Fincare Paveclean / TyreClean followed by thorough scrubbing or pressure washing at minimum of 2000psi.
Assess any existing sealer is sound, free of delamination and surface whitening. Undertake a cross hatch pull off test to a small area to assess adhesion of existing coating for further sealing.
If the existing sealer is unsuitable it is recommended that this be completely stripped off prior to new sealer being applied.
If sound, the existing sealer should be reactivated via application of Finseal Glow 100 solvent and agitated with a solvent resistant broom. Allow to dry before commencing sealing.
