Vulk - Finseal Invisi TS - Solvent based penetrating masonry sealer
Solvent based penetrating masonry sealer
Solvent based penetrating masonry sealer
Finseal Invisi TS is a clear impregnating low viscosity fluro-resin solvent-based sealer with good oleophobic and water-resistant properties for the protection of concrete, absorbent natural and synthetic stone and masonry surfaces.
Finseal Invisi TS exhibits good penetration and is fast drying, providing substrates oil and water repellent qualities, whilst being UV resistant and contributing to increased durability of treated surfaces.
Application rate will vary from 1 - 10m²/L depending on the material porosity and application method.
Dense surfaces approx. 5-10m²/L
Porous surfaces up to 1-2m²/L
Substrate saturation is essential to achieve maximum result.
Touch dry within 2 hours. 3 to 4 days to full cure at 25˚C and should not be exposed to extreme temperatures during this time. 6 hours of free drying time prior to rain is required.
Ensure substrate is clean, dust and stain free prior to application. Clean surface to remove any dirt, laitance, previous coatings or curing agents that may prevent penetration of the material.
The surface must be dry prior to application.
It is recommended to undertake a test sample to confirm the suitability of the product for specific substrates and ensure desired results are achieved.
Slowly stir the material until thoroughly mixed; Using a low-pressure sprayer fitted with an adjustable spray tip, surface must be flooded at a sufficient rate ensuring to achieve full saturation.
Substrates of greater porosity will benefit from a second application, wet on wet, to ensure penetration is achieved. The properties of the substrate such as porosity and profile will greatly influence the amount of material required.
